the problem is that it is the first time I make a construction helmet and I have doubts about the adherence ... what do you advise me? Give him hands of sandpaper ... or with a gun give him warm HELP!
@Cristian you just run the flame over areas very quickly then spray with alcohol and wipe down where you flamed. Do this several times and then put the basecoat
or just use abs hard hats or the fibermetal brand.just scuff and go to it! the ones from the depot are hdpe plastic and need to b flame treated. one less step to do with using the abs or fibermetal ones!!
or just use abs hard hats or the fibermetal brand.just scuff and go to it! the ones from the depot are hdpe plastic and need to b flame treated. one less step to do with using the abs or fibermetal ones!!
ABS hardhats are not allowed in many places. Especially refineries, chemical plants, etc. They melt when exposed to lots of chemicals. Be sure to check with the customer as to what environment he will be using the hat.
It's sad you know exactly which categories there are on Porn Hub...It's really sad that even though you have a hot wife? You still resort to fapping on the internet...or your dog and some peanut butter when you know you won't be interrupted...or you run out of Gerbils at the gay bar...
Comments
I've spoiled it ... I melted the plastic too much ... I ran out to the store to get [email protected]
There are several videos on it. @K2Concepts has one on flame treating.
But sand it first.